Recently Updated Pages
Scope
REVOLON is an external scan controller for Transmission Electron Microscopes (TEM). It's designed...
An Introduction
A scan controller is the central real-time control and acquisition unit of a scanning microscope...
Scope
Scan Control app is provided for independent and open control of point electronic GmbH scan contr...
Detectors signals cables
Digital/counting signal only Install the 1027 0012 0001 counting cable from the 100 MHz DIGITAL i...
Scope
TurboTEM PULSE uses a live gradient-based digital signal processing algorithm to identify distinc...
Description & Operation
This section gives an introduction to the scope, the graphical interface, it explains common oper...
Scope
microCAL is a software for automated geometrical microscope calibration with marker based calibra...
How do I perform a 3D Calibration?
This documentation explains the procedure for performing a 3D calibration of your microscope usin...
Adjusting the Detection Settings for Marker Measurement
This documentation describes how to adjust the settings for detecting and measuring reference mar...
File Formats Overview
This table provides an overview of the file formats used by microCAL. Topic Format Description...
Troubleshooting / FAQ
The file containing the measurement data cannot be loaded The file format you are using may not ...
Toolbars
Calibration The "Calibration" toolbar contains settings for calibration as well as functions for ...
User Interface / Command Reference
Overview No. Component Description/function 1 Toolbars see Toolbars 2 Measurement Data ...
Installation and Setup
For setup an installer is provided. The installer will guide you through the setup. If the user d...
Adjustment Settings
Adjustment settings include all settings, which are required for parameter estimation with least-...
Detection Settings
Detection settings include all settings, which are required for marker detection, decoding and su...
App Settings
The file AppSettings.json contains all app settings in JSON format and is located here: C:\Progra...
Supported Data File Formats
Overview of supported 3D (topography) and 2D (image) file formats. Due to the aim of the calibrat...
Supported Parameters
Overview of the transformation parameters available in microCAL, which correspond to the applicab...
Image B&C
This content provides detailed information about control of image brightness and contrast. It is ...